XXXAssembly table KomTec GM

Used assembly table GM, can be set up, including perforated plate and 4 manual press cylinders. Year of manufacture 2015. The variable assembly station for universal use in the assembly of assembly of wall, gable, roof and ceiling elements planked on one or two sides and ceiling elements and knee braces in frame construction. Heavy-duty basic structure of the machine frame for an absolutely flat working surface. The assembly station, on which the frame work and the beam layer are positioned laid out, clamped and nailed down at an exact angle. - The width adjustment and pressing of the elements is done motorized at the touch of a button. - The frame work is positioned via a movable pressure beam using a motorized pressure beam using motor-driven precision threaded spindles. threaded spindles. - Divided pressure beam for simultaneous processing of 2 wall elements of different heights. - The pressing pressure is infinitely adjustable by means of an overcurrent relay. - The spindle drive ensures that the wall elements are pressed absolutely parallel elements is guaranteed, even when several small wall elements are produced on the station at the same time. - As far as technically possible, the station is fully planked with a perforated sheet. The perforated plate has 17 mm holes, a thickness of 4 mm and a hole pattern of 65 mm. Manual press cylinders that can be rotated 360 degrees can be inserted here in order to be able to clamp all geometries. - The working height of the stations is approx. 700 mm. - The heavy machine construction is the basis for absolutely flat elements with an element weight of up to 4.0 tons. - 10 system grid beams with plug-in bolts, height 120 mm installed transversely in the work surface of the station, for inserting the plug-in pins, for pressing wall panels and knee blocks with a height of less than 2.50 m, and for pressing cylinders for sloping wall constructions. - Stop at the bottom and on the left side with 47 plug-in reversible bolts in stainless steel design Spacing of the mounts for stop bolts, approx. 600 mm - Installation device up to 80°(95°) angle of inclination - On both station ends and on the long side of the station opposite the pressure beams, 2 sockets and 2 compressed air connections each for connecting hand tools. - The stations are designed according to the modular principle so that they can be later with a slave station to form a complete turning station. can be added later. Working area: - Working area length (element width): from min. 1,000 - max. 12,000 mm - Working surface width (element height): from min. 595 - max. 3,500 mm - Stop height: 125 mm - Working height/table height: approx. 700 mm - Electrical data: Cable 5x2.5 square/fuse 20 A - Compressed air connection 1/2 inch hose nozzle